Based in Mobile, Alabama

Air Sealing Assessment

The house isn’t comfortable and the air can’t keep up, even when it’s running all day.

You’ve probably already tried the trifecta

You called the AC guy. You added new insulation. A roofer put in a powered attic vent. Nobody figured out what was actually causing the problem first.

Where the leaks usually are

  • Attic doors: pull-down ladders and small knee wall doors. A lot of times it’s a regular old interior door with no weatherstripping.
  • The chimney. A lot of people don’t realize the flue is open. I’ve cut a house’s total air leakage by 30% just by stuffing a towel up the chimney flue.
  • Can lights, bath vents and wall penetrations.

“We added insulation and it’s still hot.”

If you need more insulation, you should definitely get it. It’s usually just done in the wrong order. The air sealing should have been done first:

  1. Suck all the old insulation out.
  2. Clean out old wiring and debris.
  3. Look for any damage.
  4. Air seal between the living space and the attic, including can light covers foamed in place.
  5. Seal around the chimney.
  6. Then blow the insulation in.

What happens when I come out

A lot of listening first. What’s changed in the house, when it feels worse, what time of day. Then the filter, the AC coils, and a look in the attic. Then the tools: infrared camera, smoke pen, manometer, moisture and humidity meters. I want you walking around with me, looking at what I’m looking at.

On the full diagnostic, the blower door puts the house under pressure, and we can measure how much air is coming through each attic door, outlet and light. My goal is to make every house 25% less leaky the day I’m there, with foam, caulk and tape I bring with me.

What you can check this weekend

  • Your chimney flue.
  • Your air filter. Clean, and no higher than MERV 5 unless your HVAC tech says otherwise.
  • Your ductwork. Air moves like water. A duct that’s bent out of shape and makes a bunch of turns won’t flow like one that’s straight and tight.
  • Your bath vents. Make sure they’re vented outside, not into the attic.

What’s a waste of money

  • Powered attic vents. Do not do that.
  • Blowing new insulation into the attic without a good air seal.
  • A bigger air conditioner.
  • Fancy 1-inch allergen filters and HEPA filters.
  • A new AC without a third party designing the system for your house first. Then get bids on that system.

Who does the work

I’d love to leave you a DIY list. Usually the only thing you need a contractor for is actual HVAC mechanical work. Get somebody to vacuum out the old insulation, because it’s nasty. You can do the air sealing and blow it back in yourself. Nine times out of ten the work isn’t that difficult. Figuring out what it’s going to take is what gets people into trouble.

What changes once it’s sealed

The biggest thing is comfort. Less hot, humid air coming in, the cold air you’re paying for stays inside, and the house feels more balanced. If your AC is oversized, like it is in the vast majority of homes, a tighter house can bring humidity issues forward, because the AC doesn’t have to run as much. That’s still a much better situation to be in.

1-Hour Virtual Consultation $99

If you’re into doing it yourself, I’m 100% thrilled to teach you how.

Book Now

Basic Consult and Diagnostic

$400

Comes with a report showing what was found, with pictures and verifiable data, so there’s no guessing.

See what’s included

Full Home Performance Diagnostic

$1,200

Everything in the basic, plus the blower door. Your report shows your blower door score, how leaky the house is, what you can do yourself, and recommended contractors.

See what’s included
Book Now